Page 1 of 1

Extrude & Thicken

Posted: Wed Jun 17, 2020 4:46 pm
by Simon
Working on 4.1 beta.
  • Improved Extrude to follow surface orientation
  • Added Thicken to turn a thin sheet into a thick layer - great for clothes, armor and detailing
  • Improved Loft thickness to follow surface orientation
  • Improved straight segment drawing when you hold Control
This helmet was made using Slice by Curve with Detach and then Extrude/Thicken. The straps and central helmet band are Lofts. Also used Array on Rails to make the rivets.

Image

Re: Extrude & Thicken

Posted: Sun Jun 21, 2020 7:06 pm
by Kato
Nice image Simon.