Second Life: Curvy 2.0 Tutorials

Post Reply
Simon
C.E.O.
Posts: 2561
Joined: Wed Dec 01, 2004 8:13 am
Location: Kingston Upon Thames, U.K.
Contact:

Second Life: Curvy 2.0 Tutorials

Post by Simon »

Here are some Curvy 2.0 tutorials for Second Life, similar techniques should work in 3.0

Sculpted Car Seat for Second Life
Video of Sculpting a Sword Sculptie for Second Life in Curvy 3D
Making a Teapot Sculptie for InWorldZ
zenith
Posts: 3
Joined: Fri Nov 08, 2013 1:51 am

Post by zenith »

Thank you very much
Simon
C.E.O.
Posts: 2561
Joined: Wed Dec 01, 2004 8:13 am
Location: Kingston Upon Thames, U.K.
Contact:

Post by Simon »

Exporting to SL as a mesh seems like a balance of triangle count and the physics settings (convex hulls etc.).

I think you need a lot less triangles than Curvy normally creates - so make sure to adjust the Resolution slider down for Curvy primitives, and experiment with the mesh simplification commands for sculpted meshes.

Ideally you would retopo a mesh specifically for SL, but tools for that are not currently available in Curvy.
tron00100
Posts: 1
Joined: Sat Nov 18, 2017 4:45 pm

Second Life

Post by tron00100 »

It would be nice when the program could do meshes in collada and not sculpts.
Many there want low prim and sculpts are not low prims.
ALso many want have meshes.
It would be nice when the program could do this ASAP.
Post Reply