Drop to Surface
Posted: Fri Apr 05, 2024 10:54 am
In the perspective view line up the viewpoint over the piece you want to drop. Then use Mesh/Fit To/Drop to Surface (of Visible objects)
Note that I used Subdivide without smoothing to increase the mesh density of the dropped part, and after it dropped a little to far I just used the move tool, holding shift, to pull the dropped piece out of the head mesh a little.
You can drop to make more complex surfaces too
Note that I used Subdivide without smoothing to increase the mesh density of the dropped part, and after it dropped a little to far I just used the move tool, holding shift, to pull the dropped piece out of the head mesh a little.
- Drop.jpg (118.38 KiB) Viewed 21282 times
- Drop2.jpg (51.55 KiB) Viewed 21280 times