Extrude & Thicken

Discussion and updates on Curvy 3D Beta development.
Post Reply
Simon
C.E.O.
Posts: 2306
Joined: Wed Dec 01, 2004 8:13 am
Location: Kingston Upon Thames, U.K.
Contact:

Extrude & Thicken

Post by Simon »

Working on 4.1 beta.
  • Improved Extrude to follow surface orientation
  • Added Thicken to turn a thin sheet into a thick layer - great for clothes, armor and detailing
  • Improved Loft thickness to follow surface orientation
  • Improved straight segment drawing when you hold Control
This helmet was made using Slice by Curve with Detach and then Extrude/Thicken. The straps and central helmet band are Lofts. Also used Array on Rails to make the rivets.

Image
Kato
Posts: 35
Joined: Sun Sep 23, 2018 9:17 am
Contact:

Re: Extrude & Thicken

Post by Kato »

Nice image Simon.
Post Reply