This is similar to the "Fit to" mesh commands from 3.0, but will only remove volume - and so acts like a cut operation.
Trim Curve
-
Simon
- C.E.O.
- Posts: 2677
- Joined: Wed Dec 01, 2004 8:13 am
- Location: Kingston Upon Thames, U.K.
- Contact:
Trim Curve
Sometimes Booleans are overkill, and you just want to cut a shape down a bit. You can now Trim you model with a curve.
This is similar to the "Fit to" mesh commands from 3.0, but will only remove volume - and so acts like a cut operation.
This is similar to the "Fit to" mesh commands from 3.0, but will only remove volume - and so acts like a cut operation.
Re: Trim Curve
This is actually amazing! Don't believe it, but I already wanted to propose a new "Cut Off" brush. This is a super method to produce hard surface objects.